Air source

The air supply pressure can not exceed 7 kg, connect the diaphragm pump air outlet valve to a device that can provide sufficient air supply pressure, when the air supply pipe is hard, in the middle of the connection and the valve should also use a section of hose, the length of the hose should be at least 13mm above, caliber between the air inlet valve and the air supply pipe. The intake pipe and the air filter and pressure regulator in between must be secured or supported, otherwise damage may be caused to the diaphragm pump. At least one pressure regulator should be installed to ensure that the supply pressure does not exceed the upper pressure required by the pump.

Main function parameters as below : 

flow volume : 0-400 L

pressure: 8.6 pa 

absorb distance : 7M

Lift head : 82 M

entire pump measurements : L* W * H=423*314*548 mm

Weight : 24 Kg

Stainless steel pneumatic diaphragm pump

 

Features of stainless steel pneumatic diaphragm pump:

1. The stainless steel pneumatic diaphragm pump is powered by compressed air. 

2. The stainless steel pneumatic diaphragm pump is a positive displacement pump whose volume changes caused by the reciprocating deformation of the diaphragm. Its working principle is similar to that of a plunger pump. Due to the characteristics of the working principle of the diaphragm pump, the diaphragm pump has the following characteristics:

(1) The pump will not overheat: compressed air is used as power, and it is a process of expansion and heat absorption during exhaust. The temperature of the pneumatic pump is reduced when it is working, and no harmful gas is discharged.

(2) No electric sparks: The stainless steel pneumatic diaphragm pump does not use electricity for power, and prevents static sparks after being grounded.

(3) Liquids containing particles can be passed: because the volumetric work and the inlet is a ball valve, it is not easy to be blocked. 

(4) Very low shearing force on the material: How to suck in and out when working, so the agitation to the material is minimal, and it is suitable for the transportation of unstable materials. 

(5) The flow can be adjusted, and a throttle valve can be installed at the material outlet to adjust the flow 

(6) has the function of self-priming. 

(7) can run dry without danger. 

(8) Can dive for work. 

(9) The fluid that can be transported is extremely wide, ranging from low-viscosity to high-viscosity, and viscous from corrosiveness. 

(10) No complicated control system, no cables, fuses, etc. 

(11) Small size, light weight, easy to move. 

(12) No lubrication is required, so it is easy to maintain and will not pollute the working environment due to dripping. 

(13) The pump can always maintain high efficiency and will not be reduced due to wear. 

(14) 100% energy utilization, when the outlet is closed, the pump automatically stops, the equipment moves, wears, overloads, and heats up. 

(15) has no dynamic seal, easy maintenance to avoid leakage. No dead spots when working.

http://www.zqaodd-pumps.com/